BS 799-8:1988 download free

06-15-2021 comment

BS 799-8:1988 download free.British Standard Oil burning equipment Part 8. Specification for connecting dimensions between atomizing oil burners and heat generators.
BS 799-8 was accepted by CEN on 18 September 1987. CEN members are bound to comp’y with the requirements of CEN Internal Regulations which stipulate the conditions for giving BS 799-8 the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN Central Secretariat or to any CEN member.
BS 799-8 exists in three official versions (English. French. German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to CEN Central Secretariat has the same status as the official versions.
CEN members are the national standards organl?ations of Austria Belgium. Denmark. F inland. France, Germany, Greece. Ireland, Italy. Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and United Kingdom.
1 Object and field of application
BS 799-8 Is applicable to atomizing oil burners, with a thermal flow of combustion equal to or less than 150kw.
Two classes of burnen ace considered:
— burners with a thermal flow of combustion 0F <72kW
— burners with a thermal flow of combustion 0, such that: 72kW0 150kW
2 Dimensions
The connecting dimensions between burners and heat generators shall be in accordance with the dimensions given in the table as well as in figure 1.

Download infomation Go to download
Note: If possible,i really hope you can shut your adblocker.

BS ISO 15374:1998 download free

BS ISO 15374:1998 download free.Implants for surgery Requirements for production of forgings. 1 Scope BS ISO 15374 specifies requirements for the production of forgings of stainless steel, unalloyed titanium, titanium alloy or cobalt-based alloys intended to he...
Download Now

BS ISO 7902-3:1998 download

BS ISO 7902-3:1998 download.Hydrodynamic plain journal bearings under steadystate conditions Circular cylindrical bearings Part 3: Permissible operational parameters. 1 Scope This part of ISO 7902 specifies empirical permissible values for hbm, T and ,. The empirical values...
Download Now

BS EN ISO 8739:1998 pdf free download

BS EN ISO 8739:1998 pdf free download.Grooved pins Full-length parallel grooved , with pilot. 1 Scope BS EN ISO 8739 specifies the characteristics of fuIl.length parallel grooved pins, made of steel or austenitic stainless steel, with pilot...
Download Now


Anonymous netizen Fill in information