BS EN 700:1995 pdf free download

06-03-2021 comment

BS EN 700:1995 pdf free download.Fibre ropes for general service Polyethylene.
1 Scope
BS EN 700 specifies requirements for 3-strand hawser-laid and 4-strand shroud-laid ropes for general service made of polyethylene and gives rules for their designation.
2 Normative references
BS EN 700 incorporates by dated or undated references, provisions from other publications. These normative references are cited at the appropriate places in the text and the publications are listed hereafter. For dated references, subsequent amendments to or revisions of any of these publications apply to BS EN 700 only when incorporated in it by amendment or revision. For undated references the latest edition of the publication referred to applies.
EN 701:1995, Fibre ropes for general service — General specification.
EN 919, Fibre ropes for general
service — Determination of certain physical and mechanical properties.
ISO 1968, Ropes and cordage — Vocabulary.
3 Definitions
For the purposes of BS EN 700, the definitions given in ISO 1968 apply.
4 Designation
Fibre ropes shall be designated by:
— the words “fibre rope”;
— the number of this European Standard;
— the construction or type of rope (see clause 5);
— the reference number of the rope;
— the material from which the rope is made.
NOTE The material from which the rope is made may be indicated either by its full name “polyethylene” or by means of its abbreviation “PE”.
Example:
Designation of a 4-strand shroud-laid rope with a linear mass of 706 ktex corresponding to reference number 40 made of polyethylene:
Fibre rope EN 700-B-40-polyethylene.
5 Construction
Polyethylene ropes produced to this European Standard shall be made in one of the following constructions:
— type A: 3-strand hawser-laid rope
(see Figure 1);
— type B: 4-strand shroud-laid rope
(see Figure 2).
Linear density and minimum breaking force shall conform to Table 1, and Table 2 (see also Table 1 and Table 2 of EN 701:1995).
Construction, manufacture, lay, labelling, packaging, invoicing and delivery lengths, shall conform to EN 701.
6 Marking
The marking shall be carried out in accordance with clause 7 of EN 701:1995.

Download infomation Go to download
Note: If possible,i really hope you can shut your adblocker.

BS ISO 15374:1998 download free

BS ISO 15374:1998 download free.Implants for surgery Requirements for production of forgings. 1 Scope BS ISO 15374 specifies requirements for the production of forgings of stainless steel, unalloyed titanium, titanium alloy or cobalt-based alloys intended to he...
Download Now

BS ISO 7902-3:1998 download

BS ISO 7902-3:1998 download.Hydrodynamic plain journal bearings under steadystate conditions Circular cylindrical bearings Part 3: Permissible operational parameters. 1 Scope This part of ISO 7902 specifies empirical permissible values for hbm, T and ,. The empirical values...
Download Now

BS EN ISO 8739:1998 pdf free download

BS EN ISO 8739:1998 pdf free download.Grooved pins Full-length parallel grooved , with pilot. 1 Scope BS EN ISO 8739 specifies the characteristics of fuIl.length parallel grooved pins, made of steel or austenitic stainless steel, with pilot...
Download Now

LEAVE A REPLY

Anonymous netizen Fill in information