BS 800:1988 download

06-15-2021 comment

BS 800:1988 download.British Standard Specification for limits and methods of measurement of radio interference characteristics of household electrical appliances, portable tools and similar electrical apparatus.
Amendment 1 to the English version of CENELEC EN 55 014
This amendment is based on the decision taken by the CENELEC Technical Committee CISPR during its
meeting held in November 1986 in Frankfurt.
The changes to be made to the EN text are as follows.
4.1 Continuous interference
Add at the end of the existing text the following new paragraphs:
Continuous interference may be either broadband, caused by switching devices such as mechanical switches, commutators, and semiconductor regulators. or may be narrowband, caused by electronic control devices such as microprocessors.
Broadband interference is measured with a measuring receiver including a quasi-peak detector as described in Section One of CISPR Publication 16(1977).
Narrowband interference is measured with a CISPR measuring receiver in which the quasi-peak detector is replaced by an average detector. The average detector shall comply with Clause 23 of CISPR Publication 16.
Note. The hmit for narrowband interference are tentative and may be relaxed or restricted after a period of experience.
4.1.1 Frequency range 0.15 MHz to 30MHz (terminal voltages) Delete the text of the first paragraph.
4.1.2 Frequency range 30 MHz to 300 MHz (interference power) Delete the text of the first paragraph.

Download infomation Go to download
Note: If possible,i really hope you can shut your adblocker.

BS ISO 15374:1998 download free

BS ISO 15374:1998 download free.Implants for surgery Requirements for production of forgings. 1 Scope BS ISO 15374 specifies requirements for the production of forgings of stainless steel, unalloyed titanium, titanium alloy or cobalt-based alloys intended to he...
Download Now

BS ISO 7902-3:1998 download

BS ISO 7902-3:1998 download.Hydrodynamic plain journal bearings under steadystate conditions Circular cylindrical bearings Part 3: Permissible operational parameters. 1 Scope This part of ISO 7902 specifies empirical permissible values for hbm, T and ,. The empirical values...
Download Now

BS EN ISO 8739:1998 pdf free download

BS EN ISO 8739:1998 pdf free download.Grooved pins Full-length parallel grooved , with pilot. 1 Scope BS EN ISO 8739 specifies the characteristics of fuIl.length parallel grooved pins, made of steel or austenitic stainless steel, with pilot...
Download Now

LEAVE A REPLY

Anonymous netizen Fill in information